< Back to previous page

Publication

Additive manufacturing of zirconia ceramics by material jetting

Journal Contribution - Journal Article

The possibility of additive manufacturing of ceramics has been reported widely in scientific literature. This study investigates the potential of direct inkjet printing or material jetting of 3Y-TZP ceramics by assessing the microstructure and mechanical properties of the sintered printed parts. The technique allows to print in layers of 10.5 μm, with an as-printed green density of 58 % and nearly fully sintered density of 6.03 ± 0.1 g/cm3 (99.7 % TD). The dimensions of the green and sintered parts were highly accurate but showed an anisotropic roughness in function of the building direction, mainly due to the support structures. The biaxial bending and 4-point bending strength of the sintered material was found to be substantially higher in the XY direction than in the building (Z) direction. SEM and X-Ray computed tomography revealed the presence of delamination cracks, agglomerates and spherical pores, which were identified as fracture origins on fractured surfaces.
Journal: Journal of the European Ceramic Society
ISSN: 0955-2219
Issue: 10
Volume: 41
Pages: 5292 - 5306
Publication year:2021
BOF-keylabel:yes
IOF-keylabel:yes
BOF-publication weight:1
CSS-citation score:1
Authors from:Higher Education
Accessibility:Open