Publications

The AA3003 alloy is widely used as fin material in heat exchangers. The life time of these heat exchangers is mostly determined by their corrosion properties. Twin roll casting (TRC) of AA3003 material is known to often result in the formation of a macrosegregation area of alloying elements towards the centre plane of the casted strip (centre line segregation = CLS). Considering the potential exposure of cross-sectional areas of TRC material in ...

Sr is known to transform the morphology of the eutectic silicon phase as well as the Fe-rich β phase in Al-Si alloys, improving their mechanical properties. However, little is known about the effect Sr has on the (local) corrosion properties of aluminium alloys. This study investigates the effect of Sr addition to a modified AA3003 heat exchanger material on the morphology of the different phases present, especially the Fe-rich phases, as well ...

Superplastic-like forming is a newly improved sheet forming process that combines the mechanical pre-forming (also called hot drawing) with gas-driven blow forming (gas forming). Non-superplastic grade aluminium alloy 5083 (AA5083) was successfully formed using this process. In this paper, a physical-based material model with dislocation density and vacancy concentration as intrinsic foundations was employed. The model describes the overall flow ...

With recent development in the automotive and aerospace industries, the lightweight, yet inexpensive aluminum alloys are of great demand in industrial applications. In this paper, considering the limited applications in non-superplastic materials, two typical alloys of AA5083 and AA6061 were investigated and compared during high temperature tensile tests to study their formability. The results of tensile tests and microstructures were shown, ...

Superplastic forming has been considered as an attractive process in the automotive and aerospace industries. However, the disadvantages of slow forming rate, high-temperature requirement, poor thickness distribution, and expensive base material have hindered its widespread use for high production volume. In this paper, the non-superplastic grade of 5083 aluminum alloy (AA5083) sheets with thickness of 3 mm was employed in a superplastic-like ...

A model is proposed that deals with the transient mechanical anisotropy during strain-path changes in metals. The basic mechanism is assumed to be latent hardening or softening of the slip systems, dependent on if they are active or passive during deformation, reflecting microstructural mechanisms that depend on the deformation mode rather than on the crystallography. The new model captures the experimentally observed behaviour of cross ...

The purpose of this article is to develop an inverse method for adjusting the material parameters for single point incremental forming (SPIF). The main idea consists in FEM simulations of simple tests involving the SPIF specificities (the "line test") performed on the machine used for the process itself. This approach decreases the equipment cost. It has the advantage that the material parameters are fitted for heterogeneous stress and strain ...

For the first time, a multivariate approach combining targeted and untargeted data was used to obtain insight into quality changes in pasteurised mango juice (cv. ‘Totapuri’) as a function of storage (42 °C for 8 weeks). Mango juice samples were formulated with addition of different potential precursors for different quality-related chemical reactions: ascorbic acid, citric acid and sugars. Control (diluted mango puree with water), ascorbic ...